How to: |
The following procedures describe how to create, edit, or delete a channel for your event adapter as well as how to start or stop a channel. All defined event ports must be associated with a channel. You can create a channel using iWay Explorer.
To create a channel:
The Add Channel dialog box opens, where you supply information about the channel.
Note: For the current release, only the HTTP protocol is supported.
The Salesforce Event Adapter dialog box opens, where you must select an available listener type (HTTP or HTTPS) and provide values for the required parameters accordingly.
Note: For demonstration purposes, this procedure uses the HTTP listener as an example. If you want to use HTTPS, you must configure certificate management for the iWay Application Adapter for Salesforce before you configure an HTTPS listener. For more information on configuring certificates, see Certificate Management.
Note: Ensure that port 80 is accessible to the Internet from your system. This port is used to indicate where Salesforce will send the outbound message.
The channel you created is added beneath the Channels node in the left pane. In the right pane, a table summarizes the information associated with the channel. You are ready to start the channel to listen for events.
The channel you created is now active.
To edit a channel:
The Edit Channel dialog box opens.
To delete a channel:
The channel is removed from the list in the left pane.
iWay Software |