Installing the Samba Protocol Adapter

How to:

To install Samba, you must add the Samba protocol adapter to your iWay Service Manager instance during the iWay Service Manager installation. For more information on installing iWay Service Manager, see the iWay Installation and Configuration Guide.

However, if you have already installed iWay Service Manager, you can also add the Samba protocol adapter by modifying the existing iWay Service Manager installation.

This section describes how to add the Samba protocol adapter by modifying an existing iWay Service Manager installation.
Top of page
x
Procedure: How to Add the Samba Protocol Adapter

To add the Samba protocol adapter:

  1. Open the Windows Control Panel and double-click Add or Remove Programs.

    The Add or Remove Programs dialog box opens.

  2. Select iWay 6.0.1 Service Manager and click the Change/Remove button.

    The following dialog box opens.

  3. Select Add/Reinstall components and click Next.

    The iWay 6.0.1 Service Manager Select Features dialog box opens.

  4. Expand the Protocol Adapters group, select the check box for SMB/CIFS (SAMBA), and click Next.
  5. Click Finish.
  6. Stop and restart iWay Service Manager.

    Note: You must perform a hard restart. Using the Restart function in the iWay Service Manager Administration Console is not sufficient.

iWay Software