Displaying Parameters That Cannot Be Set in an Area

The ? SET NOT command produces a list of SET commands that cannot be set in a specific area. The areas for which you can find this information are the PROMPT command, report requests, the FOCPARM profile, and the HLI profile.

Syntax: How to Determine Where a Command Is Valid

? SET NOT area

where:

area

Is one of the following:

PROMPT is the PROMPT command.

ONTABLE is a report request.

FOCPARM is the FOCPARM profile.

HLIPROF is the HLI profile.

Top of page

Example: Displaying Parameters That Cannot Be Set With ON TABLE

Issuing the command

? SET NOT ONTABLE

produces the following information:

                    NON-SETTABLE ON TABLE PARAMETER SETTINGS
 
BINS          64        LANGUAGE        AMENGLISH    REBUILDMSG      1000
BLKCALC       NEW                                     SAVEMATRIX       ON
BYPANELING    OFF       MDIBINS              8000    TCPIPINT         OFF
CACHE           0       MDIPROGRESS        100000    TEMP DISK          C
COLUMNSCROLL  OFF       MODE                         TRMSD             24
DATEDISPLAY   OFF       MPRINT                NEW    TRMSW             80
DATEFNS        ON                                    TRMTYP     1  (3270)
DEFCENT        19                                    WEBHOME          OFF
EUROFILE                                             WIDTH            130
FIELDNAME     NEW                                    WINPFKEY         OLD
FOCSTACK SIZE   8                                    YRTHRESH           0
HTMLMODE      OFF       PRINTPLUS             OFF