|
The person performing the installation and maintenance procedures should have, at a minimum, a working knowledge of MVS or VM/CMS. Knowledge of FOCUS, MSO, or EDA is not required. |
In this section: |
The following are the software requirements for using the Translator:
FOCUS for S/390 Installation. FOCUS for S/390 (MVS/TSO, MSO, or VM/CMS) must be installed and fully operational. If it is not, contact your FOCUS database administrator or consult the appropriate FOCUS installation guide for installation instructions.
The FOCUS Release must be 6.5 or higher. Every copy of FOCUS has a release number and a maintenance level. To identify your release, you can either check the label of the distribution tape used to install FOCUS (the numbers are printed on it) or invoke FOCUS if it is already installed. The release is displayed each time you begin a session. To display the maintenance level, issue the ? RELEASE query command.
EDA Installation. The EDA Server for MVS or EDA Server for VM/CMS must be installed and fully operational. If it is not, contact your EDA administrator or consult the appropriate EDA installation documentation for installation instructions.
The EDA Release must be Release 3.2 or higher. Every copy of EDA has a release number and a maintenance level.
You do not have to perform any maintenance procedures to ensure proper functioning of the Translator. If you install a new release of FOCUS or the EDA Server (including maintenance releases), you do not need to reinstall the Translator. However, in VM/CMS, if you installed the Translator on the FOCUS or EDA production disk, you may either copy the Translator files to the new release or reinstall the product.
| Information Builders |