In this section: |
The initial steps differ depending on whether you are unloading from a cartridge or downloading from an FTP site.
The following is a high-level summary of how to execute ISETUP:
The following is a high-level summary of how to receive the service pack or upgrade electronically:
When this is complete, you have a basic test environment with the service pack or upgrade applied which is ready to be tested using your site's verification standards.
The following customizations from your current production installation are reapplied to the new files by ISETUP:
Important: ISETUP unloads or downloads the files for any data adapters (Interfaces) that you have in your current production release. Therefore, you do not have to allocate and unload or download the data adapter files manually. However, using the instructions in the relevant Installation Guides for those data adapters, you must reinstall every data adapter to which you want to have access in the upgraded or refreshed version of FOCUS. It is important to make sure you unload the correct files by checking the file numbers against the table of file numbers found in Unload the FOCUS Distribution Tape.
The following customizations from your original installation are not reapplied by ISETUP. For these customizations, you must follow the instructions in the FOCUS Installation Guide for your current production version of FOCUS:
Note: If these features were installed in your current production version of FOCUS, ISETUP will create any necessary libraries under the new high-level qualifier.
If you run FOCUS out of LPA libraries, you must follow do the following:
Information Builders |