How to: |
HiperFOCUS is installed and configured using SET commands. These commands must be issued from the FOCPARM ERRORS file.
HiperFOCUS requires an XC mode virtual machine. To establish XC mode, issue the following command and then re-IPL CMS:
CP SET MACHINE XC
You can install HiperFOCUS by simply adding SET HIPERINSTALL=ON to the FOCPARM entries and accepting the defaults. However, since this would not establish limits on the number of hiperspaces that FOCUS could create, it is strongly recommended that you establish operating limits using the HiperFOCUS SET parameters.
The command to activate HiperFOCUS once it is installed (SET HIPERFOCUS) can be issued from FOCPARM or in a user session or FOCEXEC. The HiperFOCUS installation and configuration parameters must be set in FOCPARM.
For more information on HiperFOCUS features and SET parameters, see the Developing Applications manual.
SET HIPERINSTALL = {ON|OFF}
where:
Installs HiperFOCUS.
Disables HiperFOCUS.
SET HIPERFOCUS = {ON|OFF}
where:
Activates HiperFOCUS. This is the default.
Deactivates HiperFOCUS.
If HiperFOCUS is not installed, The SET HIPERFOCUS command is disabled.
Information Builders |