You can test FOCUS on the production disk as follows:
Enter FOCUS by executing the CMS EXEC named FOCUS:
EXEC FOCUS
FOCUS is always entered using this CMS EXEC, which is created by the GENFS EXEC, which inserts your FOCUS segment name. When FOCUS is entered it displays the release banner. You should see a single caret (>).
Press Enter without typing anything else, not even a blank. The response you should receive is simply the word FOCUS.
Issue the following command:
EXEC CARTEST
This test FOCEXEC runs through the major test areas and prints reassuring messages if all is well. Press Enter (in full-screen mode) and CLEAR to page through the test. The end of this short test is signaled by the message:
AT END OF TEST MAJOR AREAS OK
You can return to the CMS command level by issuing the FOCUS command FIN when you receive the above message.
Information Builders |