Displaying Graph Parameters

The ? SET GRAPH command lists the parameter settings that control graphs produced with the GRAPH command. These parameters are described further in Customizing Your Environment.

Syntax: How to Display Graph Parameters

To display graph parameters, issue the command:

? SET GRAPH

Top of page

Example: Displaying Graph Parameters

Issuing the command

? SET GRAPH

produces information similar to the following:

                GRAPH PARAMETER SETTINGS
 
AUTOTICK               ON         HISTOGRAM                 ON
BARNUMB               OFF         HMAX                     .00
BARSPACE                0         HMIN                     .00
BARWIDTH                1         HSTACK                   OFF
BSTACK                OFF         HTICK                    .00
DEVICE            IBM3270         PIE                      OFF
GMISSING              OFF         VAUTO                     ON
GMISSVAL              .00         VAXIS                     66
GPROMPT               OFF         VCLASS                   .00
GRIBBON(GCOLOR)       OFF         VGRID                    OFF
GRID                  OFF         VMAX                     .00
GTREND                OFF         VMIN                     .00
HAUTO                  ON         VTICK                    .00
HAXIS                 130         VZERO                    OFF
HCLASS                .00
 
>

If you change the PLOT parameter settings, a small table appears at the end of the list:

PLOT TABLE (EBCDIC):
 
ENTER PLOT MODE   0050 (FOR 3284 WIDTH)
EXIT PLOT MODE    0018 (FOR 3284 HEIGHT)
LEFT              0000
RIGHT             0000
UP                0000
DOWN              0000

The entries in the table at the bottom are:

ENTER PLOT MODE	Width of graph on IBM 3284 or 3287 printer.
EXIT PLOT MODE	Height of graph on IBM 3284 or 3287 printer.

Ignore the parameters LEFT, RIGHT, UP, and DOWN.