Displaying Parameters That Cannot Be Set in an Area

How to:

Determine Where a Command Is Valid

The ? SET NOT command produces a list of SET commands that cannot be set in a specific area. The areas for which you can find this information are the PROMPT command, report requests, the FOCPARM profile, and the HLI profile.

Syntax: How to Determine Where a Command Is Valid

? SET NOT area

where:

area

Is one of the following:

PROMPT is the PROMPT command.

ONTABLE is a report request.

FOCPARM is the FOCPARM profile.

HLIPROF is the HLI profile.

Example: Displaying Parameters That Cannot Be Set With ON TABLE

Issuing the command

? SET NOT ONTABLE

produces the following information:

                  NON-SETTABLE ON TABLE PARAMETER SETTINGS
BINS              64     LANGUAGE         AMENGLISH      REBUILDMSG      1000 
BLKCALC          NEW                                     SAVEMATRIX        ON
BYPANELING       OFF     MDIBINS               8000      TCPIPINT         OFF
CACHE              0     MDIPROGRESS         100000      TEMP DISK          C
COLUMNSCROLL     OFF     MODE                            TRMSD             24
DATEDISPLAY      OFF     MPRINT                 NEW      TRMSW             80
DATEFNS           ON                                     TRMTYP      1 (3270)
DEFCENT           19                                     WEBHOME          OFF
EUROFILE                                                 WIDTH            130
FIELDNAME        NEW                                     WINPFKEY         OLD 
FOCSTACK SIZE      8                                     YRTHRESH           0 
HTMLMODE         OFF     PRINTPLUS              OFF